!!! Preset values of SSVA feeder parameters best fit most of the practical tasks. Contact service center or consultant to verify that they need to be changed.

Setting the additional SSVA feeder parameters:

Set the feed speed to “0”. Pressing and releasing the pushbutton at the welding burner are to select current adjustment.

Smooth start:

• Set the feed speed to “0”. Keypress and hold down  the pushbutton at the welding burner. The right symbol of the feed rate indicator flashes. Use the “+” and “–” buttons to set the desired acceleration time of wire to the speed you set: the value from 0 to 9 (the higher the number, the slower the acceleration).

“Postflow”* time:

• Set the feed speed to “0”. Keypress and hold down  the pushbutton at the welding burner. The left symbol of the feed rate indicator flashes. Use the “+” and “–” buttons to set the desired valve turn off time: the value from 0 to 9 (from 0.5 seconds to 5 seconds, respectively).

* “postflow” ― supply of the shielding gas after extinguishing the arc