Support

Setting the additional SSVA current source parameters

Setting the additional SSVA current source parameters

!!! Preset values of SSVA current source parameters best fit most of the practical tasks. Contact service center or consultant to verify that they need to be changed..

Setting additional parameters of SSVA current source for t mode ― TIG:

Press and hold down the “FUNCTIONS” button in the desired position.

Change of values is made by buttons “+” and ““, designed to change the voltage (current) values.

  • t-“1” → F “preflow”* time
  • t-“2” → F “postflow”** time
  • t-“3” → F pilot arc voltage (if set the value is “0” ― the pilot arc is off)

!!! Simultaneously pressing and holding down the “+” and “” buttons for 15 seconds (until the beep) will reset the settings of the additional TIG functions to the factory settings.

* “preflow” ― supply of the shielding gas before the arc striking
** “postflow” ― supply of the shielding gas after extinguishing the arc

 

Setting additional parameters of SSVA current source for “U” mode ― MIG/MAG:

Press and hold down the “FUNCTIONS” button in the desired position.

Change of values is made by buttons “+” and ““, designed to change the voltage (current) values.

  • U-“1” → F arc force level
  • U-“2” → F arc force time
  • U-“3” → F “burntout”* the wire when stopped
  • U-“4” → F voltage level at the arc (at the welding wire) in the standby mode (the value “0” must be used only for the drive of a feeding machine with external power supply)

!!! Simultaneously pressing and holding down the “+” and “” buttons for 15 seconds (until the beep) will reset the settings of the additional TIG functions to the factory settings.

* “burntout” – after releasing the button, the welding machine burns out the electrode wire to a certain length from the current collector to the tip of the wire